Australian Made Logo

Quality Paint at Sensible Prices

"Brinlay's Premium Range of Paints are regularly tested against all leading paint brands to ensure equal or better quality, but cost much less"
Read More

Í

65 Waratah Street
Kirrawee NSW 2232
Ph: 02 9521 8777
Fax: 02 9521 4797

Interior

Interior Paints

Exterior

Exterior Paints

Varnishes

Sealers

Sealers

Trim Colours

Trim Colours

Wood Stains

Wood Stains

Traditional Interior Wood Stain

Brinlay Traditional Interior Stain

A semi-transparent oil-based stain suitable for use on all new interior woodwork. Interior stain is a wipe-on / wipe-off stain formulated to be overcoated with polyurethane. Use on new or old timber, where all previous finishes have been removed. The surface must be clean, dry and free from oil, grease and dirt.

Application: Stir until thoroughly mixed to a uniform colour. Apply one coat with a soft cloth (a brush may also be used, but be careful not to overload). Make a small pad and work evenly into the grain. Allow to set for 10 minutes, then rub lightly with a soft cloth in a circular motion to remove any excess. The intensity of the stain colour will depend on (1) the porosity of the timber, (2) the length of time before stain is wiped off, (3) for deeper colour repeat process.

Drying Time:
Touch dry in 2 hours, allow 12 hours drying at 25°C before over-coating with polyurethane. Do not apply when temperatures are below 10°C.
Coverage:
9 – 12 square metres per litre depending on porosity of timber.
Clean Up:
Clean brushes and equipment with mineral turpentine.

Handy Hints: The final colour of the timber will be affected by the colour of the timber you are applying to, eg. Pine or mahogany; also the number of coats applied. Always test stains on an off-cut of the same timber, or a concealed part of the job before proceeding on actual job. All Brinlay Stain Colours are shown on maple.

SAFETY DIRECTIONS

Keep out of reach of children. Avoid skin contact. Provide adequate ventilation. If using indoors, keep doors and windows open while using and during drying. This product is flammable. Do not smoke during application.

FIRST AID

Swallowed:
Do not induce vomiting. Drink plenty of water and contact a doctor or Poisons Information Centre.
Eye:
If in eyes, hold eyes open, flood with water for at least 15 minutes and contact a doctor.
Skin:
If skin contact occurs, remove contaminated clothing and wash skin thoroughly. If irritation occurs, seek medical advice.

This high quality product is manufactured to have minimum environmental and health impact as modern technology allows.