Australian Made Logo

Quality Paint at Sensible Prices

"Brinlay's Premium Range of Paints are regularly tested against all leading paint brands to ensure equal or better quality, but cost much less"
Read More

Í

65 Waratah Street
Kirrawee NSW 2232
Ph: 02 9521 8777
Fax: 02 9521 4797

Interior

Interior Paints

Exterior

Exterior Paints

Varnishes

Sealers

Sealers

Trim Colours

Trim Colours

Wood Stains

Wood Stains

STAIN-COVER Oil Based 3 Way Undercoat

Premium Oil Based Brick & Plasterboard Sealer

One Hour Recover

DESCRIPTION

3Way Stain-Cover is an advanced, fast drying, oil-based, stain covering, primer, sealer and undercoat.

  • It gives the surface excellent adhesion for additional paint coats,whilst being touch dry in 30mins and recoatable in just 1 hour
  • Stain Cover is excellent for sealing back Ink, Grafitti, Rust, Marker Pen, Nicotine, Crayon, Water and Smoke stains,some heavy stains may require a 2nd coat.
  • Suitable for Interior or Exterior surfaces including bare timber,plasterboard,wallboard and pvc pipes.
  • Especially suited to badly weathered timber,absorbent and painted surfaces for both acrylic and solvent based paints has excellent sanding properties, filling, gloss hold-out.

SUITABLE PAINTING SURFACES

Suitable for both interior and exterior use over gloss and semigloss enamel paints, primers and bare timber internally. Especially suited to badly weathered, absorbent, previously painted surfaces where a turps based finish product is to be used.
Masonry-Cement, mortar and render must be cured for a minimum of 28 days prior to painting.
Timber-Suitable for most timber surfaces see preparation for more details.
Previously Painted-Suitable for undercoating all architectural coatings.

GENERAL DATA

Gloss Selection Guide
Flat

Colour: White.

Application: For best results use a brush, however it can be applied by roller or spray. When spraying, thin with Mineral Turps. Provide adequate ventilation. Temperature should be above 10ºC. Early exposure to steam, overnight dew, rain or hosing may result in damage or removal of the coating.

Coverage: Will cover approximately 10 sq. metres per litre. On rough or absorbent surfaces, this will be reduced. When spraying, coverage is approximately 10 sq. metres per litre.

Thinning: Mineral turpentine according to manufacturer’s instructions.

Drying: Touch dry in 30minutes. Recoat 1 hour on a day of 25ºC and 50% relative humidity, but will be longer in adverse conditions.

DO NOT USE IN TEMPERATURES BELOW 10 degrees C or above 30 degrees C

Clean Up: Mineral turpentine.

SURFACE PREPARATION

Sand and scrape all unsound and flaking surfaces. Remove any grease, oil or rust deposits. Fill imperfections with appropriate fill. Sand smooth, sand all gloss and semigloss surfaces to give key. .
Apply 1 – 2 coats

HEALTH AND SAFETY

For detailed information, refer to the product label and the current Material Safety Data Sheet available through Brinlay Paints.
Flammability: This product is flammable. Store and use away from sources of heat and ignition.

Toxicity: Lead free. Dry film is non-toxic.

TRANSPORT AND STORAGE

Sizes:
500ml, 1 litre, 2 litre, 4 litre, 10 litre and 20 litre
Dangerous Goods Class:
3.2
Flashpoint:
26°C
UN:
1263
Packaging Group:
III