Australian Made Logo

Quality Paint at Sensible Prices

"Brinlay's Premium Range of Paints are regularly tested against all leading paint brands to ensure equal or better quality, but cost much less"
Read More


6 Christie Street (PO Box 263)
St Marys NSW 2760
Ph: 02 9623 4022
Fax: 02 8330 5555



Interior Paints


Exterior Paints




Trim Colours

Trim Colours

Wood Stains

Wood Stains

Premium 3 Way Sealer Primer Undercoat

Premium 3 Way Sealer Primer Undercoat


This 100% acrylic based primer is a water based, general purpose primer/undercoat for use on new interior and exterior surfaces. It dries quickly, and may be over coated with either water or oil based products in the same day.


For use on gyprock, plaster, fibrous cement, timber, hardwood and masonry surfaces, and as an undercoat over thoroughly sanded old gloss or semigloss enamel. It is a durable finish in its own right and may be left some weeks before over coating.


Gloss Selection Guide
Low Sheen (approximately 5 – 10%)

Colour: White.

Application: Stir well with a broad paddle. Brush, roller or spray. Provide adequate ventilation. Temperature should be above 10ºC. Early exposure to steam, overnight dew, rain or hosing may result in damage or removal of the coating.

Coverage: Approx. 14 m² per lt. On rough or absorbent surfaces this figure may be reduced.

Thinning: Up to 100 ml of clean water per litre for spraying or application to very porous surfaces.

Drying: Touch dry in 30 minutes. Recoat 2 hours on a day of 25ºC and 50% relative humidity, but will be longer in adverse conditions.

Clean Up: Water and detergent. Dried spots can be removed using General Purpose Thinners.


Previously Painted Surfaces:

  • Ensure all surfaces are cleaned of dirt, dust, powder, grease, oil, smoke stains, cooking residues, polishes and materials detrimental to the finish and adhesion of the new paints by washing with water and detergent or sugar soap (as appropriate), rinse clean any residues.
  • Sterilise mould or moss with bleach or Brinlay Fungicidal Wash.
  • Fill surface holes with an appropriate filler and sand to match existing surface. Sand all gloss and semi-gloss paints to a flat look. Remove flaked, cracked, peeling and poorly adhered unsound paints which should be tested as follows:
  • Test surface at random by cutting a small cross (X) through the existing paints. Apply and press down firmly a piece of sticky tape over the cut. Hold the end of the tape and rip off. If the paint is removed, check other areas. Paints consistently failing test or, if any doubt to their adhesion, should be completely removed.
  • Powdering paints or kalsomine surfaces should be washed down with sugar soap and have one coat of Brinlay Binder & Conditioner applied before applying the undercoat.

Previously painted surfaces: Remove all loose and flaking paint by stripper, flame or hot air gun or mechanical means. Sand the area well, feathering off edges of remaining paints. Apply Brinlay Wood Primer.

New Timber: Suitable for all seasoned timber which is free from dirt, wax, mildew etc. Sand lightly before application and between additional coats. Do not leave for extended periods prior to applying finishing coats.


For detailed information, refer to the product label and the current Material Safety Data Sheet available through Brinlay Paints.

Flammability: This product is non-flammable. Store and use away from sources of heat and ignition.

Toxicity: Non-toxic, environmentally friendly, lead free and non-hazardous.


1 litre, 4 litre, 10 litre and 15 litre
Dangerous Goods Class:
Packaging Group: